HALL EFFECT CONTROLLER AND SPARE PARTS

Brand new hall effect board designed for hall effect joysticks used by Atari for the following games:  I, Robot,  Escape from the Planet of the Robot Monsters, and Road Runner.  Uses OEM hall effect devices.  The resistors used in this reproduction are higher tolerance metal film (1%) parts.  The circuit board itself is within original Atari spec, however exceeds spec with regard to plate thickness and edge routing.  This part is 100% interchangeable with OEM controllers.

Part #:  A046516-01

New Old Stock (NOS) OEM magnetic hall effect sensor.  Used on hall effect board.  Use these to repair your existing hall effect board.  This part is 100% interchangeable with OEM hall effect boards, every revision.  Note: Price includes two devices.

Part #:  133030-001 and 133030-002

Brand new plunger used in the upper housing assembly for centering of the joystick handle.  Made from Acetal Homopolymer (Delrin) within original Atari specification, using manufacturing information retrieved from tape and compared with NOS counterparts.  This part is used on many different joysticks made by Atari.  Refer to the part number below to determine if it will function in your device.   If you have a loose stick, use this part to correct the problem.  This part is 100% interchangeable with OEM hall effect controllers.

Part #:  039712-01

Brand new pivot ball used in the upper housing assembly for pivoting of the joystick handle.  Made from Acetal Homopolymer (Delrin) within original Atari specification, using manufacturing information retrieved from tape and compared with NOS counterparts.  This part is used on many different joysticks made by Atari.  Refer to the part number below to determine if it will function in your device.   If you have a loose stick, use this part to correct the problem.  This part is 100% interchangeable with OEM hall effect controllers.

Part #:  039716-01

Brand new pivot ball and centering plunger used in the upper housing assembly for pivoting/centering of the joystick handle.  Made from Acetal Homopolymer (Delrin) within original Atari specification, using manufacturing information retrieved from tape and compared with NOS counterparts.  These parts are used on many different joysticks made by Atari.  If you have a loose stick, use this part to correct the problem.  This part is 100% interchangeable with OEM hall effect controllers.

Brand new actuator used in the lower assembly for engaging the switches.  Made from Acetal Homopolymer (Delrin) within original Atari specification, using manufacturing information retrieved from tape and compared with NOS counterparts.  This part is used on many different joysticks made by Atari.  Refer to the part number below to determine if it will function in your device.   If you have a loose stick, use this part to correct the problem.  This part is 100% interchangeable with OEM Assault controllers.

Part #:  039714-01

Special silica-thickened, light viscosity, synthetic hydrocarbon grease intended for mechanical components that require a light level of damping (noise/chatter reduction).  This is the exact grease called out in Atari specifications with an added moly lubricant for better aluminum on aluminum lubrication.  It also has an added benefit of quieting down plastic gears!  Comes in a 10 gram tube - enough for several applications.

[Home]  [About]  [Products]  [BLOGs]  [Wanted]  [FAQ]  [Vendors]  [Order]  [Links]  [Contact]